How to mix dry feed powder and wet feed powder in the mixer?

Feed dry and wet mixer is mainly used for dry and wet mixing of feed raw materials to achieve uniform mixing of different ingredients. It is suitable for the production of various animal feeds that require dry and wet mixing in feed processing. The process of mixing dry feed powder and wet feed powder in the mixer can be completed by the following steps:

Preparation:

Ensure mixers and related equipment are clean and free of impurities to avoid contamination of the mixture.

Prepare the required dry feed powder and wet feed powder as needed and ensure that they meet the prescribed quality standards.

Adjust mixer parameters:

According to the characteristics and formula requirements of the feed, parameters such as the capacity and rotation speed of the mixer are adjusted to ensure that the required amount of feed can be accommodated and effectively mixed.

Add dry feed powder:

Open the feed inlet of the mixer and gradually add the pre-prepared dry feed powder into the mixer.

Control the addition speed of dry feed powder to avoid uneven mixing caused by too fast or too slow.

Add feed wet powder:

Gradually add the pre-prepared wet feed powder into the mixer, either by spraying or injecting.

Control the adding speed and method of wet feed powder to ensure full contact and mixing with dry feed powder.

Mixing process:

Turn on the mixer and start the stirring device to ensure that the dry feed powder and wet feed powder are fully mixed in the mixer.

As needed, the mixing time and stirring speed can be set to obtain the desired mixing effect.

Observe and adjust:

During the mixing process, observe the uniformity and moisture content of the mixture and make adjustments as necessary.

If uneven mixing or inappropriate humidity is found, the machine can be shut down in time and the parameters readjusted, or adjustments can be made by increasing/decreasing the amount of dry feed powder or wet feed powder.

Mixing is complete:

After the mixing time reaches the required time, close the mixer and open the discharge port.

Transfer the mixed feed to appropriate containers or packages for subsequent storage and use.

During the entire mixing process, the following points need to be noted:

Control the feeding speed and proportion to ensure that the mixing ratio of dry feed powder and wet feed powder meets the formula requirements.

According to the characteristics and formula requirements of the feed, adjust the parameters of the mixer, such as capacity, rotation speed, mixing time, etc.

Clean mixers and related equipment regularly to avoid cross-contamination of different batches of feed.

Carry out appropriate testing and quality control as needed to ensure that the mixed feed meets requirements.

Through the above steps and precautions, the dry feed powder and wet feed powder in the mixer can be fully mixed to obtain a uniform mixture with suitable humidity to meet the nutritional needs of different animals.